I have my 2820 set up with 2 broadband connected, i was load balancing specific ip's through wan2 and all was working fine. Also had schedules running to block ip's at certain times.
I have not changed anything in the settings that i can think of but any ip now set to use wan2 will not access the internet unless i disable wan1.
If is set ip’s to wan2 they will not work, if i set them back to wan1 they work fine.

Any ideas as it seem the 2820 has developed a mind of its own.

Thanks for any help.

I had a simialer fault

To check try do a reboot of the router ( 2820 ) so that when it comes on again WAN2 comes online first before WAN1 ( ADSL ) and see if ip's running of wan2 work but then suddenly don't work once WAN1 kicks in online

I had to revert to firmware 3.3.3 ( most reliable firmware for 2820 ) anything higher has the same issue with WAN2

My issue was WAN2 won't port forward properly once WAN1 came online , looked like both WAN's are fine but WAN2 was been disregarded once WAN1 kicked in

Hi

To check try do a reboot of the router ( 2820 ) so that when it comes on again WAN2 comes online first before WAN1 ( ADSL ) and see if ip's running of wan2 work but then suddenly don't work once WAN1 kicks in online

My issue was WAN2 won't port forward properly once WAN1 came online , looked like both WAN's are fine but WAN2 was been disregarded once WAN1 kicked in

yes this is exactly what i am getting, my firmware is as it came out the box. 3.3.4.1_232201

it was working fine for a couple of weeks. thats the strange thing.

can you go backward in formware even thoug this is what the router came with?

C

I've gone back and fourth ... so far so good , well good as far as the 2820 is ( I found that the 2820 is not the most reliable of draytek routers , 1 issue after the other )

I've ordered a new Vigor2830Vn with VigorCare and GlobalView

I hope the 2830 is reliable like my old 2800 which I gave to a friend and still going strong

Hi

does anyone know if the WAN2 issue has been addressed in the latest version of firmware 3.3.5.2 UK

cheers

chris