Hi there guys, in a bit of a pickle.

Today i tried to upgrade my fw on my 2750N from 1.4.1 to 1.5.1. However during the installation it seemed to hang on polling and nothing was happening. I left it going for about an hour but nothing happened. Eventually rebooted the draytek. Now I cannot access the home page via 192.168.1.1

All the lights on the Draytek are lit. A reset didnt do the job. I then tried to set it into TFTP mode and flash again. The flash appeared to go through according to the TFTP utitlity. I think switched the draytek on and off. However when i do so the some lights appear permanently on and i cannot access the router. Any suggestions guys. So scared I have bricked my lovely Draytek

phew, ok managed to get it working...

used the Router tools v4.2.1 to reflash it after i set it into tftp mode.

Model : Vigor2750n
Firmware Version : v1.5.2_Beta