alanplum241276 wrote: Would you recommend going from RC4 to 8c?

I'm after the VDSL stats page which seems to be missing from RC4.

As long you master reset after loading the RC8 is not problem

Hmm, I see RC9 is now available too.

http://draytek.co.uk/support/download/v2860_373RC9.zip

Anyone tried that one?

I've just loaded it. Seems to work so far. Only immediately obvious changes is there are now four wan ports xdsl/ether/usb1/usb2

Has it got VDSL status page?

I don't see it

Firmware 3.7.3 final has been released

******************************************************************************
Release Notes for Vigor2860 series

Firmware Version : 3.7.3 (First Release)
Build Date : 20th August 2013
Release Date : 29th August 2013
Applicable Models : Vigor2860, Vigor2860n, Vigor2860Vn
VDSL Firmware Version : 05.04.08.00.00.06
Locale : UK Only
******************************************************************************

[New Features]
1. Wireless Wizard.
2. Bonjour protocol service [Applications > Bonjour]
3. APPE Support List added to Web UI
4. USB Device Status for modem and disk.
5. DNS Filter
6. Support Multi-VLAN for WAN2.
7. Support 6in4 Static Tunnel & 6rd for IPv6.

[Improvements]
1. Add SNMP v3.
2. UP to 16 SSL VPN Tunnels can be configured.
3. Add Time Quota & Data Quota for User Management.
4. Support Load-Balance/Route Policy.
5. Support Operation Mode and 5G settings for AP management.
6. New web page design for Login Customization.
7. Support web content filter (WCF) based on fragFINN.
8. Support Hub and Spoke IPsec VPN between Cyberoam router and Vigor router.
9. Support wireless VLAN.
10. Support web portal setup.
11. Resolved Web UI compatibility issue with IE10.

[Known Issue]
- Load-Balance / Route Policy (see point Improvement #4) only applies to traffic received on one of the LAN
interfaces.