Hi - just started using AP800 WAPs (used Draytek routers for a long time). Strange issue I have found in our office. If I connect over VPN to the location where the AP800's are installed, I cannot bring up the browser mgmt page for them. However they do ping, and I can telnet to them. If I am on the LAN where the AP800's are connected, I can bring up the browser mgmt page fine (http://192.168.3.5).

Any suggestions? Have I missed something obvious in the mgmt setup?

more info on this... the problem does not exist when my PC is directly VPN connected to LAN-B where the 2 x AP800's are installed.

However if my PC has an IP on LAN-A, and LAN-A is joined to LAN-B via Draytek site-to-site VPN (both 2830's) , then my PC browser cannot bring up either AP800 management page. It can telnet no issue. This must be something in the AP800 firmware because I can access browser pages for other LAN-B devices like printers, switch etc.

Any thoughts?