I'm trying to use the superhub2 with the 2925. I've reset the superhub (factory). Then put in into "modem mode" and connected it (correct port or the SH2) to the WAN1 port on the Draytek.
Draytek set to Ethernet & auto IP. I've powered stuff off/on and waited 5 minutes between powering them on and there's a link light on the draytek WAN1 port.
The auto IP is being populated every time, no issue, all green, but...but I cannot get any Internet!
Tried other cables that I know work, but still no change

DHCP works, just no networking past the Draytek.

SuperHub2 factory reset it and tried again. Also factory reset the Draytek a couple of times - still same result, it gets the WAN IP, etc, but I get no Internet.
Any ideas would be appreciated!

UPDATE:
I have a new SuperHub2 on the way to see if this fixes the issue.
Superhub - 192.168.100.1 ("Modem mode").
2925 - 192.168.1.1
Connected PC = GW: 192.168.1.1, IP (DHCP)= 192.168.1.20 (255.255.255.0) - name servers 8.8.8.8 & 8.8.4.4.

2925 shows SH2 WAN IP 82.blah

We have a fixed IP from Virgin too.

When i was using VM i had it working at dhcp tab with specify an ip address (static)
you can find your external ip here
http://whatismyipaddress.com/
Vm does not change often the ip so is fine ... but even if change once an year still got the static ip aytomatic