I've just purchased & installed a new Vigor 130 ADSL/VDSL Modem, which I've installed and so far is working fine coupled up to a pfSense firewall setup, using bridged PPPoE authentication from within pfSense.

I'm now trying to enable SNMP for monitoring of the modem, as I've created a secondary interface so I can connect to the modems Admin UI, which I can do (connecting to 192.168.2.1), however, it appears that the majority of options described in the User Manual are not showing?

The entire list of options available to me is as follows:

Online Status
Physical Connection
Internet Access
General Setup
PPPoE/PPPoA
MPoA / Static or dynamic IP
LAN
General Setup

System Maintenance
System Status
Administrator Password
Configuration Backup
Management
Reboot System
Firmware Upgrade
Diagnostics
ARP Cache Table
DHCP Table

So, going from the User Manual, I'm missing a considerable amount of options here... And as for SNMP, when reading the user manual section 3.8.7, the only options I have in this section is IPv4 Management Setup, which only contains the following configurable items:

• Router Name


• Default: Disable Auto-Logout


• Management Port Setup (of which only 1 management port is displayed - HTTP)


• TLS/SSL Encryption Setup (tried enabled and disabled)

There is no IPv6 Management tab, going from the user manual, there is also no Telnet port, FTP or SSH port configurable as shown in the user manual, and also no SNMP Setup options.

Am I missing something?

Thanks

Appears going into the web console, I can at least access these options:

Code:

> mngt snmp ? Usage: mngt snmp [- | ... ] -h show usage -e <1/2> ,1 Turn on , 2 Turn off SNMP -g , Get Community (max. 23 characters) -s , Set Community (max. 23 characters) -m or / , Manager Host IP Support 3 IPs, separated by ',' -t , Trap Community(max. 23 characters) -n , Notification Host IP Support 2 IPs, separated by ',' -T , Trap Timeout <0~999> -V List SNMP setting Example: mngt snmp -e 1 -g draytek -s DK -m 192.168.1.20,192.168.5.192/26,10.20.3.40/24 -t trapcom -n 192.168.1.20,10.20.3.40 -T 88

And checking the current status, shows the following:

Code:

> mngt snmp -V SNMP Agent is [Disable]. Get Community is [public]. Set Community is [private]. Manager Host IP is Trap Community is [public]. Notification Host IP is Trap Timeout is 10 seconds.

So now I need to figure out the correct configuration string to pass (as in the example...)

Hi, I am not sure if you are ONLY trying to have access to the UI of the 130 ... if yes ... take a look this if will work ... is from the 120 but both should be the same settings
https://forum.pfsense.org/index.php?topic=45606.msg239032#msg239032

for the latest user guides (if cover your needs) here 1.01 pdf
http://www.draytek.com/index.php?option=com_k2&view=item&layout=item&id=5240&Itemid=3810&lang=en#downloads

I've already got access to the UI thanks, its the amount of options which im missing. And lack of SNMP configurability within the UI.

I'll get some pictures later, should hopefully explain it better.

OK, so this is what I see within the Vigor 130 UI...




Yet in the manual, it shows as this:




So yeah, I'm a tad confused here...

SNMP is not supported on the Vigor 130; it is only intended as a transparent bridge, as per spec. on the web site.