Has anyone else had the issue with their port forwards not working? I have setup a couple of port forwards for RDPing into the PCs here. All working fine for ages, but since upgrading to 3.3.5.2 they are patchy - reboot the router and they work, then a few hours later they stop working - all of them.

I have this problem I have several port redirects that used to work. However now my NAS box port redirect does not work yet the one to my AP700 management page does!

I've posted seperately about UPNP port redirect 8080 not working, previously all ok.
I checked the UPNP port redirection table via telnet all looks ok (see below). The other UPNP ports redirections work ok i.e. 20, 21, 80, 443.
If I manually enter the port 8080 redirection in the NAT table all is ok. Any ideas- poor firmware??

Is this forum monitored by draytek technical support?

> upnp nat
****************** IGD NAT Status ****************

((0))
InternalClient >>192.168.1.10<<, RemoteHost >>0.0.0.0<<
InternalPort >>21<<, ExternalPort >>21<<
PortMapProtocol >>TCP<<
The tmpvirtual server index >>0<<
PortMapLeaseDuration >>0<<, PortMapEnabled >>1<<
FTP/FTPS
((1))
InternalClient >>192.168.1.10<<, RemoteHost >>0.0.0.0<<
InternalPort >>8080<<, ExternalPort >>8080<<
PortMapProtocol >>TCP<<
The tmpvirtual server index >>0<<
PortMapLeaseDuration >>0<<, PortMapEnabled >>1<<
Web Admin
((2))
InternalClient >>192.168.1.10<<, RemoteHost >>0.0.0.0<<
InternalPort >>20<<, ExternalPort >>20<<
PortMapProtocol >>TCP<<
The tmpvirtual server index >>1<<
PortMapLeaseDuration >>0<<, PortMapEnabled >>1<<
FTP/FTPS
((3))
InternalClient >>192.168.1.10<<, RemoteHost >>0.0.0.0<<
InternalPort >>80<<, ExternalPort >>80<<
PortMapProtocol >>TCP<<
The tmpvirtual server index >>2<<
PortMapLeaseDuration >>0<<, PortMapEnabled >>1<<
Web Server/Multimedia Station
((4))

I had a version of 3.3.5.2 on that was supposed to cope better with dodgy adsl (211801 alternative)

I have since "upgraded" again to the latest and haven't had the port forward issue since. Either of you two on the firmware above?

ta

I'm using Firmware Version: 3.3.5.2_232201 which I understand is the latest firmware from the UK support site. Is there a later version available from a different site?
I'm not using the ADSL function on the router because I have BT Infinity which terminates on the WAN Ethernet port.

Sounds like 3.3.5.2 is dodgy where is the working software located?

I am only using the latest one on the UK site like yours.
I use ADSL and ethernet (FTTC) here...