Hello all,

I have the following configuration :
Router : 3220 - 5 vlan with dhcp on each vlan
Switch : G2280
Access point 1 : AP903 - 192.168.1.20 (root on mesh mode) - SSID 1 - Vlan ID 1 / SSID 2 - Vlan ID 2 / SSID 3 - Vlan ID 3 / SSID 4 - Vlan ID 4
Access point 2 : AP903 - 192.168.1.21 (node 1) - SSID 1 - Vlan ID 1 / SSID 2 - Vlan ID 2 / SSID 3 - Vlan ID 3 / SSID 4 - Vlan ID 4

AP 2 is sync with AP 1 (same parameters)

When I connect on AP 1 on SSID ID i the connection is on the right vlan (i).
When I connect on AP 2 (node) on SSID ID i the connection is always on the vlan 1 then the tag id doesn't works for the node (I have the same problem with all my nodes).

Does anyone has an idea of the problem ?

Thanks a lot for your help

Hi, what behaviour are you expecting with this configuration?

Is "Enable Bridge VLAN to Mesh" ticked? (Best to check on both of them, since they seem a bit reluctant to transfer the entire configuration automatically )

Dear Jonathan,

I would like to be on a specific vlan when I am connected to SSID 3 and then to start hotspot authentification on this specific vlan.

hornbyp wrote:
Is "Enable Bridge VLAN to Mesh" ticked? (Best to check on both of them, since they seem a bit reluctant to transfer the entire configuration automatically )

You're right this parameter was not sync on the nodes .
I will check this tomorrow

The problem was ""Enable Bridge VLAN to Mesh" was not sync on nodes
Now everything is ok.

Thanks a lot for your help.

Best regards

Raphaël