Hi

Just got an upgrade to a 500 Mpbs fiber line from my service provider. If I connect directly to the service provider termination box I can download between 150- 200 Mpbs. (bypassing the 2920 router)

But if I go thou the 2920 router only getting around 70 Mbps throughput, have connect the router using wan 2 to the service provider termination but still no joy.

Any suggestions?

Thanks
Andrew

Turn off QoS and bandwidth management?

Are you using WAN1 or WAN2?

Thanks Voodle for the reply

both Qos and bandwidth management where disabled all ready. And the router is connected to wan2.

To be on the safe side, I reset the router to the default configuration and tried again, go upto 80-85 Mpbs this time but not close to the 150 Mpbs limit of the router.

Thanks
A