Hello,

Since a few days, I made changes to my 2927, trying to configure Admin Acces from the WAN1, adding some firewall rules, and playing around... 
And since then, I must have done something wrong, because:

- Everytime I want to access a new URL (from the LAN, passing through the router), the connection seems blocked for a while (sometimes up to 10 seconds), and then the webpage is returned. Then, all subsequent pages on the same website are super fast to load.
-  A couple of times, all outbound calls (LAN to WAN) were blocked completely. The only way to make it work again was to reboot the router.

Is it a known issue? Do you have an idea about where I should go and check?

Thanks,

Ben

I reply to myself to give you an update. After some time, it finally worked perfectly again?!?!?!?!

Since I changed parameters, then set them back, is there any 'time' before these changes take effect?

Thanks