DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

Vigor3300 Load Balancing

  • neil_m
  • Topic Author
  • Offline
  • New Member
  • New Member
More
08 Jul 2009 11:40 #56632 by neil_m
Vigor3300 Load Balancing was created by neil_m
Folks,

I am trying to load balance over three adsl modems to no avail.


Equipment:

1x Vigor 3300V (Firmware Version: 2.5.8 (EN))
3x Vigor 100


Info:

The router seems to be "up" ok. The router will also see all three of the WAN's in WAN Status, showing each as "Connected" under "Connection Status".

Upon trying to use the router say as the proxy in IE, I get the usual error "Internet Explorer cannot display the webpage".

PPPoE/PPTP info has been entered (username, password, authentication)

Network - WAN. Load Balance is set to "Enable", Backup being "Disabled". WAN1, 2 and 3 are set to IP Mode PPPoE, Active, Load Balanced and relevant weighting applied (30, 30, 40).

The lines have been tested individually.


Should I have a static route in? (Advanced / Static Route)

Does anyone have any info on setting up the Load Balancing?


Thanks in advance folks, i'm not totally au fait with it all.


Neil

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami