I'm having trouble getting a Vigor 2910 and Vigor 110 modem connected to Bethere. The settings I have are:-

Vigor 2910

PPPoE Client Mode Enabled.
Username and password blank.
Mode: Arp Detect
PPP Authentication: Pap or Chap
Fixed IP Address: My BE IP address
MAC Address : BEBox MAC address

Vigor 110 (MPoA settings)

MPoA Enabled
encapsulation - 1483 bridged IP LLC
VPI to 0
VCI to 101
Modulation - multimode

The Vigor 110 is correctly syncing at a decent rate using ADSL2+, however the Vigor 2910 WAN status is disconnected with the message:-

Message [ PPPoE : No response from server side. ]

I used the following guide as the basis for this setup:-

http://www.draytek.co.uk/support/kb_vigor100_setup.html

Any thoughts/suggestions would be most welcome!

David

I've sorted this by switching the 2910 to static IP...