Hi All,

Has anyone working 2820VN Router
On Firmware 3.3.4
With O2 ISP / ADSL ?????

My 2820VN Router was on firmware 3.3.0, which i upgarded it to Firmware 3.3.4 and now its not working.

i am using following settings.

2. Click on tab 'MPoA(RFC1483/2684) and enable
3. a. Change Multi-PVC channel to channel 2
b. VPI = 0
c. VCI = 101
d. Modulation = ADSL2+(G.992.5)
e. WAN Connection Detection Mode = Arp Detect
f. Select obtain an IP address Automatically

No Joy at all.

after spending 3 hours lastnight I gave up.
Tonight i will apply firmware 3.3.3, and see if i can get it to work.

Did you upgrade to 3.3.4 with .all or .rst ?

rothers wrote: Did you upgrade to 3.3.4 with .all or .rst ?

Upgraded to.all

.all upgrade with 3.3.4 has been known to result in corrupted firmware.

I'd try applying 3.3.3 .all and if that doesn't work make a note of your settings then apply 3.3.3 .rst

I'm happily running 3.3.4_rc10 on a 20mb O2 LLU line with my 2820Vn. I've not moved up to the final release due to the bugs in DHCP and MAC address binding.

I have the same problem and have tried all recent firmwares with the .rst and .all. I cannot get BE working. I get ADSL showtime and WAN1 all stays red with no IP, GW IP and all zeros.

My connection was working before I asked BE to change me to AnnexA and fastpath. It was on Annex M. I may have to ask them to switch me back in the meantime.

Help!