Hi all

I have just updated my 2820 to firmware v2820_3341_232201_A UK using the web interface and its gone on ok, But i seem to loose being able to dial my adsl in anymore.

I was on firmware Vigor2820_V3.3.2.1_AnnexA_232201 and it all works fine.
After the update, i get full adsl sync, but the modem never diales in and it i try to dial it, it does nothing.

flashed it back to Vigor2820_V3.3.2.1_AnnexA_232201 and alls working fine as normal.

Anyone able to point me in the correct direction on this?

3.3.2.1 isn't such a good firmware unfortunately, I think the no ADSL problem is likely to be caused by the config file on the router, so it would be a good idea to take a backup of the router's current configuration, then update to the 3.3.4.1 firmware using the .rst file and check whether it is able to connect to ADSL then once reconfigured manually.

i would, but sadly at the moment i cant as i cant find my paperwork from my ISP with the dam password on it for the dial up
Is there i way i can get it via telnet or anything on the draytek?

You were right, thanks.

Got hold of my ISP details.
updated router. (full reset)
re-setup isp.
dialed in.

Now just got the fun job of setting all my ports and filters ;)

Thanks for the help