Hi Guys

How do I configure the Draytek 2920 to use IP NATing?

We have 16 IP's allocated to us via our ISP and I've put the following information into the WAN IP settings

IP: 213.x.x.130
Subnet: 255.255.255.240
Gateway: 213.x.x.129

But how would I go about assigning one of the IP's to an internal device? or use 1-1 natting?

Did you read this - http://www.draytek.co.uk/support/kb_vigor_2ndsubnet.html ?

Not sure that the 2920 supports this, but that would be my first option.

This then gives you the option to have devices on your LAN that get their IP addresses using DHCP and use NAT to the Internet.

Also, you can configure any hosts on your LAN with direct public IP addresses. Remember that they will be accessible from the outside world on these addresses so would need some sort of firewall protection.

Just what I was looking for, thanks alot