Hello we have a 2820n currently working with one internet connection,
we have had a new line installed so we can add a second connection for load balancing.

Firstly I would like to setup the 2820n so WAN1 is dedicated for the Mailserver as we send email from a static IP and have mail delivered via MX record to same static IP address.

I would like WAN 2 setup for everything else.

Whats the best way to set this up?

Thank you for any help

have a look at this post - exactly the same question !!!

http://www.forum.draytek.co.uk/viewtopic.php?t=15410&highlight=

Many thanks

I'm trying to add the settings below to the Load Balance Policy

Protocol: Any
WAN: WAN1 - NO FAILOVER
SRC IP start: leave blank
SRC IP end: leave blank
Dest IP start: leave blank
Dest IP end: leave blank
Dest Port start: 25
Dest Port end: 25

second rule:

Protocol: Any
WAN: WAN2 - This time you can enable fail over if required
SRC IP start: leave blank
SRC IP end: leave blank
Dest IP start: leave blank
Dest IP end: leave blank
Dest Port start: leave blank
Dest Port end: leave blank

When I press save and go back and view the settings it doesn't seem to save the details. for example in the first rule I cant see port 25.

I'm using Model Name : Vigor2820n
Firmware Version : 3.3.3_232201
Build Date/Time : Oct 23 2009 15:23:15
ADSL Firmware Version : 232201_A Hardware: Annex A

Maybe its time to upgrade to Firmware 3.3.4.1

Or even 3.3.5.1 - ftp://ftp.draytek.com/Vigor2820/Firmware/V3.3.5.1/

Has anyone seen the load balance policy not save the details before?