Hi,

I have the current config the vigor 2800 has the routed interface configured with the router address assigned by our ISP. The NAT interface has been configureed with a 192.168 address. I have split the four ports into two VLANs (0,1) ports 1 & 2 are on VLAN0, ports 3 & 4, VLAN1. VLAN0 has two systems on with public configureed IP address's out of our pool, VLAN1 has a connection to the internal switch.

Currently the 192.168 internal address will not NAT any connections, I can see the connections in the ARP table and NAT sessions table but no traffic ever comes back. The Public interfaces work but performance is poor.

Is there a problem with this configuration ?