Hi all!

We have a few ports on our 2820 open to all, but there are a few ports (say, 8514) that I'd like to open to specific external IP addresses only. Would anyone be able to tell me if this is possible outside of setting up a LAN to LAN or a Remote Dial-in User?

Thanks in advance!

Yes this should be possible.

Service Type Object would, I think, be the place to define the ports.

IP Object, would, I think, be the place to list your specific external IP addresses.

IP Group, would, I think, be a practical way to group all of these together to use in your rules.

Firewall >> Fileter Setup >> 2. Default Data Filter would then be where you pull together all of the above in a rule.

Regards, Neal

That looks to be exactly what I was looking for. Thanks very much for your help nealuk!