Vigor 2600 Plus, also have a 2600G, both using firmware 2.5.9 UK. Firefox 6 used to config.

On the 'Wired VLAN Setup' config page, the OK button does nothing, and the changes are not saved.

If no ports are selected, pressing OK does give an error message. But, with a correct selection of ports, pressing OK does nothing at all. Reloading the page after pressing OK shows that no changes were saved.

Does anyone know if this is a bug in the 2.5.9 firmware, and/or if there is any workaround?

No ideas on this?

Have tried 2.5.7 and 2.5.9 UK2 firmware, identical result.

Have tried other browsers as well, but no joy.

The rate control page's OK button is likewise dead.

Find it hard to believe this isn't a firmware bug, as two routers behave identically.

Have you tried IE instead. There have been comments before about using Browsers other than IE sometimes does not work.

Neil..

g6ifs wrote: Have you tried IE instead. There have been comments before about using Browsers other than IE sometimes does not work.
Neil..

You're right. Not only that, but it only works in SOME versions of IE. I'd tried that before but with no joy. Eventually in desperation took a test computer and tried a few different versions. Got it to work in IE7.

Thx.

IWRConsultancy wrote:
You're right. Not only that, but it only works in SOME versions of IE. I'd tried that before but with no joy. Eventually in desperation took a test computer and tried a few different versions. Got it to work in IE7.
Thx.

Rate Control worked for me using IE9 but I had to set Compatibility View selectable from the Tools menu.

My setup is a Vigor 2600 plus and 2.5.9UK firmware.