Hey

I am booked in tomorrow to get a 5 new static IP addresses and was just wondering how I configure and use these with the router?



Do I allocate this within here?

Yes this is the correct setting. Then depends what you want to do with the extra IPs?

If you want just randomly NAT into any of 5 then tick Join NAT IP Pool with all of them and router will use them for all traffic.

If you want to NAT specific IP to device add the IPs to WAN IP LIST, then go to NAT and Address Mapping to assign public IP to device within network.

If your applying the new static addresses to other devices then you need to make sure you enable IP routing under LAN / General setup.

LAN IP Network Configuration
For NAT Usage
For NAT Mode For IP Routing Mode
1st IP Address 192.168.1.1
1st Subnet Mask 255.255.255.0
For IP Routing Usage Enable Disable
2nd IP Address WAN address
2nd Subnet Mask 255.255.255.248