Hi,

I've been tasked to get this working and have checked though the forum and it seems relatively simple, however as I'm on a tight time schedule I thought I'd get as much configured in advance.

I've done the following:

a) Upgraded to 3.3.7.2_232201 using Factory Reset + set up LAN/DHCP

In WAN >> General Setup
b) Disabled WAN1
c) Enabled WAN2 with a Display Name of "Infinity" (for clarity only)
d) Enabled VLAN Insertion tag with a value of 101 (I saw this on a post somewhere. is it necessary)

In WAN >> Intenet Access
e) Enabled PPPoE
f) Added my ISP (Zen) assigned username/password and left everything else as default.


Is there anything else I need to do or change that I might have missed ??
Do I need anything in WAN >> Multi-PVCs ?

Many thanks in advance

Paul

pg_bennett wrote: ...c) Enabled WAN2 with a Display Name of "Infinity" (for clarity only)...

Never put a Display Name in - I know it helps you but it is used in the PPPoE and can screw things up with the ISP as they arent expecting to see your friendly name ;)

Best regards,

Neal

Thanks Neal. I'll remove that.
Other than that, does it look ok ?

Paul

pg_bennett wrote: ...d) Enabled VLAN Insertion tag with a value of 101 (I saw this on a post somewhere. is it necessary)...

I would try it without this first, as I think that setting is usually applied in the 2850 model, which actually manages the line. You'll have the Openreach Modem managing the line, so you may not need this.

pg_bennett wrote: ...Do I need anything in WAN >> Multi-PVCs ?...

Nope - I think you're good to go.

perfect ..... I hope

Thanks for your help.