I had my ISP changed and i want to keep the draytek 2820 configration as it is...
try to connect the new ISP cable just replacing the old one but it did work
keep in mind i have both of them active,
what to do to make it work for the new one....with or without go the admin control panel

daytek vigar 2830

little more info? what you mean replacing the old one? router? and what admin panel you don't want to go at isp router or 2830?

thanx for the reply

i have 2 internet service provider(talk talk and bt) ..(two sockets)
my draytek vigar 2830 connected to the talk talk (socket) and is working fine
i wanted to use the bt which i got yesterday...
what i did i just changed the cable that running from talk talk to the draytek with the one comming from bt
it did nt work
do i have to go admin cpanel of the draytek and what to change there
if not what to do?
i hope this explained better

thanx

You will need to change the Username and Password

That's right you need to change the connection username and password

for example: from 0123456789@talktalk.net A1B2C3D5E to bthomehub@btinternet.com 12345

in the WAN >> Internet Access >> WAN1 PPPoE/PPPoA Details Page top right hand corner section: ISP Access Setup

same as: http://www.draytek.com/.upload/Demo/Vigor2830/v3.3.6.1db/doc/inet4mwa.htm

Best regards, Neal

Thanx i appreciate ur replies
i better find out the username and the password for the hub...because i lost them


regards
ibrahim