Hi,

One of my clients has a 2850n and we would like to push all VOIP traffic down WAN1 and all http traffic down WAN2, is this possible?

I don't want to load balance as the VOIP has to send and receive from the same connection and we have found the load balancing to cause problems with this.

Thanks in advance.

Ross

crateboy wrote: ...is this possible?...

Yes

crateboy wrote: ...http traffic down WAN2, is this possible?...

Use Load Balance for source port 80 and 443 and set it to WAN2 only ( or use WAN2 first to give you some failover for when it breaks :wink: )

crateboy wrote: ...VOIP traffic down WAN1...

Same principle I think, use Load Balance for source lan devices: you IP phone internal IP lan range and set it to WAN2 only ( or use WAN1 first to give you some failover for when it breaks :wink: )

crateboy wrote: ...I don't want to load balance...

however, using the above config I think you'll get it to perform the way you want.

Best regards, Neal