Hi,

Just got a 2830 and have 4 VLANs that cannot talk to one another which is what I want. All works fine and all of them can get the internet.

One thing I wanted to do was set the 4th VLAN to have bandwidth limits (public wifi) but when I enable it, it affects all VLANs.

The IP addresses are as follows

VLAN 1 - 192.168.1.X
VALN 2 - 192.168.2.X
VLAN 3 - 192.168.3.X
VLAN 4 - 192.168.4.X

Im enabling the Bandwidth Management and adding the following into the limitation list

Shared

Start IP 192.168.4.2
End IP 192.168.4.254

Tx 400kb
RX 4000kb

When I click "OK" the bandwidth management works as im doing a speed test from a machine in that range but when I test the speed test from any other machine on any of the other VLANs with an IP outside of the scope of bandwidth management, it gets restricted as well. If i disable the bandwidth management then everyone speeds up again.

It's on the latest firmware and I did reboot it after enabling the bandwidth management

Did yuo set the defaults on Tx/RX to 0 so the rest get the unlimited amount?


You can do the same with the Smart Limit Bandwitch set both to 0 and the rest not in the range will get Unlimited bandwidth

I dont think I did - ill give it a whirl and report back