Does anyone know how to configure the Digit Map that will allow me to direct calls to VOIP or PSTN without having to enter #0 on the phone handset (this works fine). I have tried various combinations in the digit map but have failed so far. Vigor 2820Vn

What would you use to identify which call goes down which line?



This setup is a little overcomplicated maybe, dialling 9 as a prefix will make the call go out over PSTN.
the ? is a wildcard and the second entry would allow numbers between 1 and 7 digits to go over PSTN automatically, which should work for local calls and emergency numbers. All other numbers between 8 and 15 digits with no prefix would go through SIP

This didn't work for me. Dialling 9 before the PSTN call picks the line after a few seconds but there is no dialtone. If it did work I would have hoped that between dialling the 9 and getting the pstn dialtone would have been the time it takes to call the relay.

Did you try entering the digits (including the pre-fixed '9'), then pressing the 'dial' or 'call' button on the phone?

Rob