Hi configured this 2850 with Spitfire as WAN 1 and works like GEM.
Now when i am trying to set-up the Orange 3G Dongle (which works fine on the laptop ) it wouldn't connect.
Can some please advise on what i am doing wrong ?
Under status it is disconnected and i didn't see at least once under status connected.
Here are the the setup details i have on the router.
Wan --> General Setup
WAN3
(Orange 3G) V USB/- 0 / 0 Always On
Under WAN >> General Setup
WAN 3
Enable: Yes
Display Name: Orange 3G
Physical Mode: USB
Physical Type: Auto Negotiate
Line Speed(Kbps):
DownLink : 0
UpLink : 0
Active Mode: Always On
Under WAN >> Internet Access Scree
WAN3 Orange 3G USB 3G/4G USB Modem ( PPP MODE) Details Page
3G/4G USB Modem(PPP mode) Enable
SIM PIN code ****
Modem Initial String APN:businessbroadband
(Default:AT&FE0V1X1&D2&C1S0=0)
APN Name : Blank
Modem Initial String2 : AT
Modem Dial String: ATDT*99#
(Default:ATDT*99#, CDMA:ATDT#777, TD-SCDMA:ATDT*98*1#)
PPP Username : Blank (Optional)
PPP Password : Blank (Optional)
PPP Authentication : PAP or Chap
WAN Connection Detection
Mode : ARP Detect
Ping IP : grayes out
TTL: Blank
Under Status Screen i get this and nothing happens even when i click Dail PPP
WAN 3 Status >> Dial PPP
Enable Line Name Mode Up Time Signal
Yes USB Orange 3G PPP 00:00:00 -
IP GW IP TX Packets TX Rate(Bps) RX Packets RX Rate(Bps)
--- --- 0 0 0 0
Please advise.
thanks
RG
