Hi All,

Searched for posts associated with this and could not find any ?

Does anyone have the correct settings for connecting to Virgin Broadband on a 2130 ? I am currently using a Netgear WNDR3700 which is different completely.

I am just getting WAN Disconnected all of the time ??

Thanks

Gary

Hi is it adsl or cable?

It is Cable ...

Thanks

Gary

I don't have this model but until a member comes with more instructions you can try at
WAN >> Internet Access >> enable and give a go via static ip
Reboot both 2130 & SH (better set it at modem mode)
If not get the ip & submusk automatic follow the same reboots after set it via DHCP method

Here some posts if will help you by cloning mac address
http://www.forum.draytek.co.uk/viewtopic.php?f=2&t=18049&p=75132&hilit=2130#p75132
If you connect & speed is lower then see this post
http://community.virginmedia.com/t5/Up-to-30Mb-Setup-Equipment/draytek-2130n-Super-hub-modem-mode-drop-in-speed/td-p/1099349
and turn off qos & dos or set them higher value

With my 2850 is set with VM 100mb via static or dymanic ip and uses DHCP

Thanks M8, I will give it a go, I did find one post you replied on in regards to the cloned mac address and I think this could be the problem.

Cheers

Gary