howdy

just purchased and setup a 2960.... installed the latest firmware.. and tested getting out on to the internet... all good thus far

i am looking to achieve the following and was hoping someone could point me in the right direction

our ISP has issued us with 1 static IP address for the router.. and a block of static ip addresses for each of the servers that we will be running

each of the servers has 2 ethernet ports... 1 will be configured with a LAN IP and the other with a WAN IP

so... how do i go about making the WAN IP addresses "visible" thru the 2960

any help greatly appreciated

thanks in advance

yukioMishima