Is there anywhere in the 2860 tat you can get hold of error rates ?

It seems that some models have a "VDSL status" command whereas the 2850 doesn't. The "adsl status" doesn't give FEC values...

Thanks ... Andy

Have you tried the following in telnet?

Code:

wan vdsl show adv1

Thanks but that give me nothing

Code:

wan vdsl show basic

gives:

VDSL2
Link Status: SHOWTIME
Firmware Version: 05-04-08-00-00-06
VDSL2 Profile: 17A
Basic Status Upstream Downstream Unit
Actual Data Rate: 20000 56036 Kb/s
SNR: 5 17 0.1dB

Code:

wan vdsl show ?

Code:

> wan vdsl show ? VDSL Show Status wan vdsl show [basic/adv1/adv2] : Display VDSL Status wan vdsl show [10/16] [oid] : Display single value

That should output a list of valid commands.

Jason,

That's all there is ...

> wan vdsl show ?
VDSL Show Status
wan vdsl show [basic] : Display VDSL Status

Oh thats not very good, I would of imagined it would of supported the same commands as the 2850n.

I've ran out of things to suggest!