Hi All,

I have a Vigor 2830n with an internet connection into both WAN1 and WAN2. I would like to set these up to load balance as we can only get a max of 3mbps down each line. I have no problem with setting this up but therein lies a problem.

We currently have an IPCortex PABX (SIP lines) within the company and due to restrictions from the provider (unless we purchase there internet connections) we are only able to run these over a single ip address. So i need to configure the 2830n to route all incoming/outgoing SIP traffic through WAN1 only leaving all other connections free to chose whichever line has the higher speed.

I have tried in vain to find what i am looking for online so was hoping someone here could help?

Many thanks in advance as I'm pretty new to the world of networking.

Any help at all anyone???

sorry never tried myself because have not pones, voip etc but only i am posting few links from draytek support if will help & you are not aware
perhaps if you give them a static ip address & then to set it work only at wan 1 at load balance?

http://www.draytek.com/index.php?option=com_k2&view=item&id=5181&Itemid=293&lang=en
http://www.draytek.co.uk/archive/kb/kb_load_balancing.html

http://www.draytek.co.uk/archive/router_faq.html
http://www.draytek.com/index.php?option=com_k2&view=itemlist&layout=category&task=&id=&Itemid=293&lang=en

Thanks for the response, ill have a look through those links and hopefully my answers will be in there somewhere.