I'm setting up our new 2960 (to replace our ageing 2950), and I just can't see how or where to setup Open Ports. On the old 2950 it is under NAT menu, but it just isn't there on the 2960. I have the latest firmware. Any help would be appreciated

Hi i don't have the model but must be at NAT > port redirection (on the left) then press ADD (with a small green plus +) on top of the page
(firmware 1.0.8)

Thanks for the reply. yes I suppose I could use port redirection. Normally would use this to redirect WAN facing port - for example 12345 to internal LAN port 3389 RDP.
On the older Vigor 2950 I'd use "Open Ports" for Port 25 incoming SMTP traffic, rather than "redirect" WAN port 25 to LAN port 25.