I have a problem with a router draytek 2830vn

in wan1 right through ppoe adsl is connected, it works fine

in wan 2 is connected right through ethernet, with a static IP from my ISP

put the ip, gateway, dns, the link status appears connected but have no internet connection, the router to the lan, but I can remotely access the router with the static IP

I did a test with another router, and it works, all the lan machines have internet

the draytek firmware version is 3.6.7

and hope you can help me with this problem

regards

wan>general setup have you enable wan2 & always on?
if its ok then try at loadbalance / route policy & tick both wans 1 & 2 or just the wan you are using
Is still issues lan general > setup make sure the details page is enable DHCP
Last LAN >> Static Route Setup just tick it (enable) with any address & network interface try combinations

If one step is successful do not try the other suggestions for getting confuse with the settings

yes wan1 and wan2 are enabled and always on, if i put wan1 mode backup, disconnect wan1. wan2 is enabled but without internet on lan !

i have just edit my previous post please check again some other steps

if its ok then try at loadbalance / route policy & tick both wans 1 & 2 or just the wan you are using
Is still issues lan general > setup make sure the details page is enable DHCP
Last LAN >> Static Route Setup just tick it (enable) with any address & network interface try combinations

apparently load balance works, can access remotly to a server, trouhg wan2

Thanks for the support

Regards from Mexico !

good to know it works & thanks for the report, seems with latest firmware 3.6.7 have change some settings ... previous firmwares not need this the load balance to be ticket for the wan 2 to work
Best wishes