Hi all,

I've just bought a second 2960 as a backup to a 2960 I have in a datacentre, I backed up my config from my original and restored it to the new, all went well.

Then I was going through the config to check that it had all been applied and I see they have tweaked the interface between the 1.0.6 and 1.07.1 firmwares, the biggest concern I have is that when creating firewall rules I cannot seem to set the Source IP Address as ANY, it seems to be completely controlled by IP OBJECT and IP GROUP, if I go to define an IP OBJECT I get the choice of Single / Range / Subnet - so if I leave the source blank is that going to be the equivalent of Source = ANY?

Are my firewall rules going to work?

(I did try and downgrade the firmware but it wouldn't allow me).

Any information would be much appreciated.

Many thanks,

Christian