I have an eight IP static address range A.B.C.128-135, the router has an IP address A.B.C.134 and NATs onto my LAN.
I have a server PC for FTP and HTTP on static address A.B.C.129.
I can access the PC on A.B.C.129 for FTP and HTTP from the LAN but not from an external IP address, this all used to work fine with my 2800.
The PC on A.B.C.129 can access outwards to the Internet OK.
I've not changed any firewall settings away from the defaults.

ISTR there was a configuration on the 2800 to set the A.B.C.128/29 network range, but can't find a similar config on the 2830

Anyone suggest what I need to configure, and where?

MTIA

at System Maintenance >> Management > Internet Access Control > Allow management from the Internet tick the small boxes
That should give access and for wan (based on latest firmware)

babis3g wrote: at System Maintenance >> Management > Internet Access Control > Allow management from the Internet tick the small boxes
That should give access and for wan (based on latest firmware)

Thanks for the reply, tried this but it causes HTTP requests to the A.B.C.129 address to be handled by the router (address A.B.C.134) rather than going to the web server PC on A.B.C.129.