Good morning all ,

I have a Vigor AP 800 for about 2 years , couple of months ago I disconnected the device due to a network upgrade , also my entire Ip adress range changed from 10.0.0.x to 192.168.68.x

Yesterday I needed this AP again and since I didn't remember the ip adress it had I did a factory reset ( I think).
But I am still unable to logon the accespoint.

I followed the steps of the manual ( no issues changing the ip adress on my computer , did that loads of time before to 192.168.1.9) , connected the AP 800 with a cable to the computer. But the accespoint is not there.

What Am I doing wrong , I have 3 of those accespoint and I never had an issue setting them up a first time.

I assume a factory reset also change back the Ip adress to 192,168.1.1??

Thanks for the help ,
Cor

The default address should be 192.168.1.2

Thanks mr Basher ,

Just read the documentation again as well , and indeed it says everywhere 192.168.68.2 :oops:
Note to myself , don't do this stuff when you're tired and should be sleeping :?

Thanks a lot!,
Cor

Got another small issue ,

The AP is showing 2 SSID , although the "Enable 2 Subnet (Simulate 2 APs)" is not selected. The second one keeps showing.
How do I disable that one?


Thanks,
Cor

Delete the text in the 2nd SSID field then click OK, that disables it.