Hi Guys,

Can anyone confirm that the Data Flow Monitor option on the 2860 will only report traffic on non-IP Routed Subnets? i.e. only subnets subject to NAT will show traffic information?

Kind Regards, Will.

It works for us up until firmware version 3.8.2 on the draytek 2860. 3.8.4.3_BT seems to break Data Flow in routing mode.
Try using the VLAN option for example LAN2 and put port 2 to 6 in LAN2 and enable LAN 2 for routed mode. Leave LAN 1 and Port1 in NAT. see if it shows up then as i dont think the default routed mode works

It seems broken for me even in basic non IP routed mode on v 3.8.4.4 - it shows sessions but not throughput for each connection.

just got hold of 3.8.5_rc6a_bt, this now support IKEv2 so i will be testing VPNs, i'll see if DataFlow Monitor is fixed.