Has anyone tried the 4.4.3.1 firmware lots of new features in there.

I wondered how buggy it is?

Yes, I have just upgraded to it and came here to see if anyone else had posted about it.

The first things I noticed:

-The dashboard page is slower to load.

-The CPU usage percent bar no longer appears to update, it just loads whenever you refresh the page and stays stuck on whatever it was at that time.

-The protect config with password does not seem to work. I have tried several times to create a password protected config, which is successful, but when trying to restore it the message always says that it failed. I'm definitely entering the correct password. So for now I am not using a password for that.

-Also if you download one password protected config file, then you can't do it again; the page just goes blank. You have to reboot the router to make the feature work again.

Haven't noticed any other issues so far.

So far no issues with the firmware. In my case the dashboard is more responsive haven't noticed the cpu however it seems to be always 1% so probably isn't working.

Currently had three unplanned resets since updating to 4.4.3.1.

First one was a few hours after updating last week, next two were very specifically at midnight last night & 13:00 today (28-10-24).

Still investigating possible causes. Router had been rock solid up till the update.

Updated last Thursday and three unscheduled reboots since then...

First was approximately 24 hours after the update and then we've had one at midnight on Sunday and exactly 13:00 today - very strange!

Initially thought it had to be a schedule thing, but we have absolutely no schedules set up.

Prior to update, router had been rock solid. Investigations are ongoing...

Thought we'd fixed the issue where adding anything to bind ip to mac resulted in ipv4 web sites dropping out after a while. Nope updated the list today an hour later all ipv4 only web sites stopped working so had to reboot the router.

I've got two BT lines and ipv6 available on both but will only bind on the first one wan that comes up and sits merrily away requested an ipv6 address but never getting one. A feature that all drayteks suffer from. Would be interesting too see what happens if I had another provider that also had ipv6 and whether the problem would persist. I suspect it would.