DrayTek UK Users' Community Forum
Help, Advice and Solutions from DrayTek Users
vigor 2927ax - NaN on data flow monitor
- receive
- Topic Author
- Offline
- Banned
Less
More
- Posts: 4
- Thank you received: 0
22 Sep 2023 11:21 #102872
by receive
vigor 2927ax - NaN on data flow monitor was created by receive
Hi, i just upgraded to the latest firmware version (4.4.3) and in Diagnostic - Data Flow Monitor instead of tx and rx rates i only get "NaN"... Any idea or suggestions?
Thanks,
Thanks,
Please Log in or Create an account to join the conversation.
- mbames
- Offline
- Member
Less
More
- Posts: 326
- Thank you received: 0
22 Sep 2023 13:27 #102873
by mbames
Replied by mbames on topic Re: vigor 2927ax - NaN on data flow monitor
NaN = not a number.
If you've just restarted the router or enabled DFM wait a bit and see if it fixes itself....
If you've just restarted the router or enabled DFM wait a bit and see if it fixes itself....
Please Log in or Create an account to join the conversation.
- piste basher
- Offline
- Big Contributor
Less
More
- Posts: 1193
- Thank you received: 7
22 Sep 2023 13:56 #102874
by piste basher
Replied by piste basher on topic Re: vigor 2927ax - NaN on data flow monitor
I usually wait until the firmware appears on the UK site but I'll give this a go on my 2927ax and report back
Please Log in or Create an account to join the conversation.
- piste basher
- Offline
- Big Contributor
Less
More
- Posts: 1193
- Thank you received: 7
22 Sep 2023 14:08 #102875
by piste basher
Replied by piste basher on topic Re: vigor 2927ax - NaN on data flow monitor
Well DFM seems to work OK on mine - I note that it now reports rates in "K" rather than thousands of bps as it did previously. I'll keep an eye out for any other anomalies.
Please Log in or Create an account to join the conversation.
- receive
- Topic Author
- Offline
- Banned
Less
More
- Posts: 4
- Thank you received: 0
24 Sep 2023 18:41 #102878
by receive
Replied by receive on topic Re: vigor 2927ax - NaN on data flow monitor
thanks for you feedbacks.. i've waited 48+ hours so far and restarted multiple times without success. i'm reverting to 4.4.3.2 and wait to a new firmware upgrade that fisse (hopefully) the issue.
thanks again
thanks again
Please Log in or Create an account to join the conversation.
- esvfi2022
- Offline
- New Member
Less
More
- Posts: 1
- Thank you received: 0
02 Oct 2023 12:48 #102891
by esvfi2022
Replied by esvfi2022 on topic Re: vigor 2927ax - NaN on data flow monitor
We are seeing the same as this on our 2927s with firmware from UK site.
Please Log in or Create an account to join the conversation.
Moderators: Chris, Sami
Copyright © 2024 DrayTek