DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

Struggling with 920RPD and Bridge-Point to Point

  • lindsaybraine
  • Topic Author
  • Offline
  • New Member
  • New Member
More
08 Feb 2020 15:58 #95536 by lindsaybraine
I'm hoping someone on this forum can lend some insight - and I will declare upfront I am new to Draytek products.

I have purchased two Draytek 920RPD to bridge a network between 2 buildings on a site that are just 10M apart and with unobstructed line of sight.

Having taken delivery - I have the two devices at home, but cannot see an easy way to setup the bridge between the two. Having trawled the Internet there is information/videos that show a configuration option of AP Bridge Point-to-Point (for example : https://www.draytek.com/support/knowledge-base/5267)

But the Point-to-Point setup as a simple option does not appear on the Web UI for the 920RPD.

Can anyone shed some light and offer guidance as to how to configure Point-to-Point bridges

Please Log in or Create an account to join the conversation.

More
14 Feb 2020 13:57 #95575 by admin
Based on other wireless products, I'd guess you need to set them into WDS mode..but really I'd ask support as not many people (relatively) do PtP links so might not be any users on here...



Forum Administrator

Please Log in or Create an account to join the conversation.

More
15 Feb 2020 22:23 #95581 by clivers
Have a look at this video from Draytek NZ. This might help you out.
https://www.youtube.com/watch?v=EsgyN39yLI8

Please Log in or Create an account to join the conversation.

More
16 Feb 2020 08:58 #95582 by piste basher
Replied by piste basher on topic Re: Struggling with 920RPD and Bridge-Point to Point
Unfortunately I suspect that video will not be of much use to the OP because, as he points out, the 920R does not have a "bridge point to point" option. However, as admin says, it does appear to offer a WDS facility in "General Setup". I use two AP902's to bridge in "Bridge WDS mode" and it looks to me as though enabling each 920R WDS and inputting their MAC addresses as peers of each other should work in the same way.

Please Log in or Create an account to join the conversation.

More
18 Feb 2020 12:42 #95594 by admin3
Set the APs up as Mesh Root & Node, connect them locally to get them to add each other's MAC address. Then increase the distance.

WDS is now part of Mesh - you can set MAC addresses manually from the WLAN General Setup page once Mesh is enabled. Potentially you could set up the WDS link manually that way, but Mesh automates that part.



Forum Administrator

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami