XunilX wrote: From Draytek support:

If you want the 2860 to act as just a Modem and obtain Sync and not do any Routing then you would first need to update the firmware to 3.7.4.1 from here

http://www.draytek.co.uk/support/downloads

Then you would set the following

WAN > Internet access > WAN1 = PPPOE/PPPOA - Select Enable and Tick "PPPoE Pass-through for Wired LAN" Then save and reboot.

The go to

WAN > Internet access > WAN1 = MPOA/Static or dynamic - Select Disable and Tick "Enable Bridge Mode"

Save and reboot.

When you log back in the WAN > Internet access > WAN1 should show "Access Mode" as "None" and the "Details page" should be grayed out.

The Router is now acting as just a modem to gain ADSL sync.

So, firmware version depending, yes, it can