Does anyone have any idea when we may see a new formware for the 2850Vn?

I'm on 3.6.2 & have had to turn my Samba service off to prevent constant reboots - I'd really like to be able to turn it on again, especially as I should be finally getting FTTC next month.

+1
I'm hopefully getting VDSL next month so would like a firmware update as I have heard that the current version can have problems with this. I'd also like to sort out the SixXS.net IPv6 problem.

there is one beta 3.6.3 rc3 here
ftp://ftp.draytek.pl/Seria_2850/Firmware/beta/
not sure if will follow rc4 or just publish it later as official

babis3g wrote: there is one beta 3.6.3 rc3 here
ftp://ftp.draytek.pl/Seria_2850/Firmware/beta/
not sure if will follow rc4 or just publish it later as official

I know that 3.6.3 RC4 exists as Draytek Support have mentioned it in an email to me regarding IPv6 tunnel testing.

I'd heard about the Polish firmware - looks like I was right not to use it if a RC4 is going to come out. I think I'll give it another few weeks & go with the newest one when my VDSL order finally goes in.

Is anyone on the forum using either RC3 or RC4 & if so are the reboots due to Samba and the VDSL problems fixed?

i am using the rc3 from the polish web
not using samba to confirm and vdsl with rc3 is the same version as 3.6.2 but the vdsl light that will keep flashing (on-off) even if is not in use (the vdsl modem)and will make jitter to my adsl line is sorted
is a good firmware for my adsl line
with 3.6.3 rc1 my adsl was getting disconnections but with rc3 2471201 is not
if rc4 will come out it may needs a master reset
any one got it for me to try? but the annex A ? thanks