I'm not using VLAN's at all and no immediate plans to do so. Do you think I am ok with 1.0.6.1 ?

Have you had a reply from Draytek support about your VLAN problem yet ?

1 console suggestion to try but had already reverted back to 1.0.6 , which is the following attached

I also checked with the Draytek engineers and they have suggested to run a
following command when this happens.

sh draytekv3900
You'll get # prompt, now run following commands

# /etc/init.d/fpp_tx_enable stop
# /etc/init.d/fpp_tx_enable start

I got the 2960 a couple of weeks ago. Working great so far, I'm on 110Mg and it copes with that no problem. It hasn't crashed yet. I had the 2910 and 2930 previously but the 2930 couldn't cope with my broadband speed so had to retire it.

Been using the PPTP VPN and this has worked without problem also.

Things i've not been able to work out yet, is how to create firewall rules for IPv6. No option of entering addresses or other items. Not sure if it's me yet, but am getting quite familiar with IPV6.

I've been impressed so far.

Does anyone know if it's possible to create an always on dial out vpn connection which only applies to a single device (ip) on the lan ?

To elaborate I want to have a connection to a vpn with an end point in the usa which allows me to watch their version of Netflix - but only on a single device (tv) on my Lan.