So the UK did not post the vector version of the 3.7.4.3 update, confusing!

Ok, I have now got that version and will run it tonight to see what happens. Cannot make my sync any worse I am currently down to 43Mbps.

I'll leave the other other beta until I have tested this for a few days.

marjohn56 wrote: So the UK did not post the vector version of the 3.7.4.3 update, confusing!

Ok, I have now got that version and will run it tonight to see what happens. Cannot make my sync any worse I am currently down to 43Mbps.

I'll leave the other other beta until I have tested this for a few days.

i think no there is not vector in UK site
Try the steps above according how dlm works give a reboot after 1-3 days (assuming dlm will find better stable connection by time) if dlm not kick you before

Do you know if noise cancellation is enabled by default or does it have to be set via telnet. I've been using that beta for a few days with no problems and no disconnects. It synced at the same speeds as the official vectoring firmware.

i am not sure because i dont have the 2860 for testing the beta ( i have the 2760 which are all same modem codes & chipsets) ... you can check few commands here that may helps but if you have no issues i suggest to leave it alone as it is
http://www.forum.draytek.co.uk/viewtopic.php?f=2&t=19713#p81488
check the modem codes, perhaps are both the same modem codes, at wan > general setup > dsl modem code there is one more if you want to try which may be better but if is working good leave it as it is

perhaps the command vdsl opt g.vector ? will show

> vdsl opt g.vector ?
% vdsl optn g.vector [ on | off]
% Current g.vector feature: ON

thanks, then if you have the beta from the Turkish FTP is the vectoring one